Nokia N96 manual Share live video or video clips, 138, Umts connection settings

Make calls

138

your device. Your service provider may send you the settings over the air or give you a list of the needed parameters.

To add a SIP address to a contact card, do the following:

1.Press , and select Contacts.

2.Open the contact card (or start a new card for that person).

3.Select Options > Add detail > Share video.

4.Enter the SIP address in the format username@domainname (you can use an IP address instead of a domain name).

If you do not know the SIP address for the contact, you can use the phone number of the recipient, including the country code, to share video (if supported by the network service provider).

UMTS connection settings

To set up your UMTS connection, do the following:

●Contact your service provider to establish an agreement for you to use the UMTS network.

●Ensure that your device UMTS access point connection settings are configured properly.

Share live video or video clips

During an active voice call, select Options > Share video:

1.To share live video during the call, select Live video.

To share a video clip, select Recorded clip. A list of video clips saved in the device memory, the mass memory, or a memory card (if available) opens. Select the clip you want to share.

You may need to convert the video clip into a suitable format to be able to share it. If Clip must be converted for sharing. Continue? is shown, select OK.

2.Your device sends the invitation to the SIP address. If the recipient has several SIP addresses or phone numbers including the country code saved in Contacts, select the desired address or number. If the SIP address or phone number of the recipient is not available, enter the address or number of the recipient including the country code, and select OK to send the invitation.

Sharing begins automatically when the recipient accepts the invitation.

Options during video sharing

to zoom the video (available for sender only)

to adjust the brightness (available for sender only)

or to mute or unmute the microphone or to switch the loudspeaker on and off