Maintenance and Trouble-shooting
Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department
1.SYMPTOM: THE POWER DOES NOT TURN ON
a.Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet. (See How to Plug in the Power Cord on page 7.) Use only a
b.After the power cord has been plugged in, make sure that the key is fully inserted into the console. (See step 2 on page 9.)
c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
d. Check the on/off switch located at the front of the treadmill near the power cord. The switch must be in the on position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
c |
|
Tripped | Reset |
d |
|
On |
|
Position |
|
a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Check to make sure that the on/off switch is in the on position. (See 1. d. above.)
c. Make sure that the power cord is plugged in.
d. Remove the key from the console. Reinsert the key fully into the console. (See step 2 on page 9.)
e. If the treadmill still will not run, please call our Customer Service Department
3.SYMPTOM: AN ERROR CODE (“E1” OR “E6”) APPEARS ON THE CONSOLE
a.If the console detects an incline error, an “E6” may appear in the INCLINE/DISTANCE display when the INCLINE buttons are pressed, and when the display shows the current incline level. If this error code appears, remove the key from the console, wait for ten seconds, and then reinsert the key. If the error code appears again, call our Customer Service Department. Do not operate the treadmill until the problem is corrected.
b.If the console detects a speed error (no speed signal, an erratic speed signal, etc.), an “E1” may appear in the SPEED display. If this error codes appears, remove the key from the console, wait for ten seconds, and then reinsert the key. If the error code appears again, call our Customer Service Department. Do not oper- ate the treadmill until the problem is corrected.
15
