4.Place two Weight Bumpers (19) over the indicated holes in the Stabilizer (5).

Insert the two Weight Guides (23) into the Weight Bumpers (19) and the Stabilizer (5).

Attach the indicated Weight Guide (23) to the Stabilizer (5) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42, and a 3/8Ó Nylon Jamnut (63).

5.IMPORTANT: If you purchased the optional weight expansion set, please refer to the userÕs manual accompanying the set to assemble the weights. After you have assembled the weights, refer back to this manual and continue with step 7 on page 8.

See the inset drawing. Open the parts bag labeled ÒWeight InsertsÓ. Press two Weight Inserts (77) into the indicated holes in each Weight (26). Make sure the large pin groove is oriented as shown.

Slide all of the Weights (26) onto the Weight Guides

(23).Make sure the Weights are oriented correctly. The holes must be on the side shown.

Slide the Top Weight (16) and the Weight Tube (36) onto the Weight Guides (23). Insert the Weight Tube into the Weights (26).

Slide the welded tubes on the Top Frame (1) over the upper ends of the Weight Guides (23). Align the bracket on the Top Frame with the indicated holes in the Main Upright (3). Insert two 3/8Ó x 3Ó Bolts (45) into the holes. Thread a 3/8Ó Nylon Locknut (50) onto the lower Bolt. Do not thread a Locknut onto the upper Bolt yet.

Attach the Weight Guides (23) to the Top Frame (1) with two 3/8Ó x 1 3/4Ó Bolts (60) and two 3/8Ó Nylon Locknuts (50).

6.Press two 2Ó Square Inner Caps (33) into the Press Frame (12).

Disassemble the pre-attached Pivot Rod (27). Attach the Press Frame (12) to the Main Upright (3) with the Pivot Rod, the two Large Washers (53), and the two 3/8Ó Nylon Locknuts (63) as shown. Make sure that the Press Frame is turned so the Large Bushings

(87)are at the angle shown.

Fully tighten all of the Nylon Locknuts used in steps 1, 2, and 6.

4

 

 

 

5

 

 

23

 

 

 

 

 

 

 

 

 

19

63

 

19

 

 

 

 

 

 

55

 

 

 

 

42

 

 

55

 

 

 

 

 

 

 

42

54

 

 

 

 

5

50

1

 

45

 

 

 

 

3

 

 

 

50

 

Welded

 

60

 

Tubes

 

 

 

23

 

 

 

 

16

 

 

 

 

36

 

 

77

 

 

 

 

 

 

 

26

26

 

 

 

 

Holes

 

 

Large Pin

 

 

Groove

 

 

 

 

6

 

 

33

3

 

 

 

63

 

 

 

 

 

 

 

 

53

 

 

 

 

27

 

 

 

 

12

 

 

63

53

 

 

 

 

 

87

7

 

 

 

 

Page 7
Image 7
NordicTrack GRT500 manual Welded Tubes Holes Large Pin Groove