5.Identify the Left Pedal (10), which has a notch near the right side. Place the Left Pedal on the Left Pedal Leg (4). Next, apply the entire contents of one of the

included Teflon ® lubricant packets to the long side of an M8 x 79mm Bolt Set (65) and the faces of the two indicated Upper Body Arm Bushings (12). Have a sec- ond person hold the lower end of the left Upper Body Arm (29) inside of the bracket on the Left Pedal Leg. Align the indicated holes, and attach the Left Pedal

and the left Upper Body Arm to the Left Pedal Leg with the M8 x 79mm Bolt Set.

Attach the other end of the Left Pedal (10) to the Left Pedal Leg (4) with two M8 x 54mm Button Screws (83).

Repeat this step on the right side of the elliptical exer- ciser.

See step 2. Tighten the two M10 x 108mm Button

Screws (70).

6.The Console (17) requires four “D” batteries (not included); alkaline batteries are recommended. Slide the battery cover off the Console. Insert four batteries

into the battery compartment.

Make sure that the bat-

teries are oriented as shown by the diagram inside

the battery compartment.

Slide the battery cover

back onto the Console. N

ote: When the batteries are

installed correctly, the fan will turn on for a moment.

7.Remove the ground wire screw from the Upright (2). Attach the ground wire to the Upright with the ground wire screw as shown.

Have another person hold the Console (17) near the Upright (2). Connect the ground wire to the ground wire on the Console. Connect the Upper Wire Harness

(30)to the wire harness on the Console. Connect the two Pulse Wires (20) to the pulse wires on the Console.

Carefully insert all excess wiring down into the Upright

(2). Attach the Console to the Upright with four M4 x 16mm Screws (94). (Note: The Screws may be found

in the console box.) Be careful to avoid pinching the wires.

5

 

65

 

 

29

 

10

 

 

Lube

 

Notch

65

 

 

 

Face

 

 

Lube

12

 

 

5

 

 

4

 

 

83

6

 

 

 

 

17

 

 

Batteries

 

 

Battery

 

 

Cover

7

 

17

Do not pinch

 

the wires

 

during this

step.

 

 

2

30

 

 

94

 

20

 

 

 

 

Ground Wire Screw

94

 

 

 

 

Ground

 

 

Wire

8. Make sure that all parts of

the elliptical exerciser are

properly tightened.

Cover the floor beneath the

elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.

 

The elliptical exerciser is now fully assembled. If you

have purchased the optional chest pulse sensor

 

(see page 18), see page

7.

 

 

6

Page 6
Image 6
NordicTrack NEL07940 user manual Wires, Properly tightened