NordicTrack NEL07940 user manual Assembly, M10 Split 6mm Spacer M4 x 16mm

ASSEMBLY

Assembly requires two persons.	Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrenches and your own phillips screwdriver		and
rubber mallet	.

As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly.

The number in parentheses below each drawing refers to the key number of the part, from the PART LIST on

page 21. The second number refers to the quantity used in assembly.	Note: Some small parts may have been
pre-assembled. If a part is not in the parts bag, check to see if it is pre-assembled.

M10 Split	7.6mm Spacer	M4 x 16mm	M8 x 54mm Button Screw (83)–4
Washer (73)–2	(47)–2	Screw (94)–4
M8 x 44mm Button Screw (84)–8		M8 x 79mm Bolt Set (65)–2
		M10 x 108mm Button Screw (70)–2

1.Identify the Front Stabilizer (8). While another person lifts the front of the Frame (1) and holds the Pedal Legs (4, 5) in the position shown, attach the Front Stabilizer to the Frame with four M8 x 44mm Button Screws (84) and a Support Plate (64).

While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (not shown) to the Frame in the same way.

1
1	4, 5
	8
64	84
84

4