NordicTrack NTC3015.0 Wire Harnesses 51, Make sure Wire Harnesses Do not get Pinched, This step

1.Attach the Left Front Stabilizer (15) to the left side of the Upright Frame (5) with three M8 x 22mm Button Screws (54) and three M8 Split Washers (55). Make sure that the Left Front Stabilizer is turned so the Wheel (17) is facing forward as shown.

Attach the Right Front Stabilizer (40) to the right side of the Upright Frame (5) in the same way.

2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 54mm Button Screws (52) and four M8 Split Washers (55).

3.While another person lifts the front of the Frame (1), connect the Middle Wire Harness (51) to the Lower Wire Harness (43). Next, slide the Upright Frame (5) into the Frame. Be careful to avoid pinching the

Wire Harnesses (51, 43).

Attach the Upright Frame (5) to the Frame (1) with four M10 x 54mm Button Screws (56), four 6.35mm Spacers (62), and four M10 Split Washers (71).

1
17	15	40
	55	5
	55
	54
	54
2
	1
	16
	55	55
	52	52
3
	5
		43
	51
	Make sure the	62
	Wire Harnesses	71
	do not get	1
	pinched and
	damaged during
	this step.
		56
		56

6