5. While another person holds the Left Handlebar (6) near |
the Upright (3), connect the Handgrip Pulse Wire (70) |
to the Pulse Extension Wire (98). Insert the excess |
wiring into the Left Handlebar. |
Hold two Handlebar Bushings (66) around the rectan- |
gular tube on the left side of the Upright (3). Slide the |
Left Handlebar (6) onto the Handlebar Bushings and |
the tube on the Upright; be careful not to damage the |
the Handgrip Pulse Wire (70) or the Pulse Extension |
5
66
70 
28 
5
3
Wire (98). Attach the Left Handlebar with two M8 x |
35mm Button Bolts (24), two M8 Split Washers (54), |
and two M8 Nylon Locknuts (28); be careful not to |
damage the Wires as you insert the Button Bolts. |
Firmly tighten the Nylon Locknuts. |
Attach the Right Handlebar (5) in the same way. |
6. While another person holds the Console (4) near the |
6
98
54 24
Be careful
to avoid
pinching the
Wires (70,
98)during this step.
Upright (3), connect Extension Wire Harness (77), the |
Pulse Extension Wire (98), and the ground wires to the |
corresponding wires on the Console. Insert any slack |
wire up into the Console and down into the Upright. |
Attach the Console (4) to the Upright (3) with four |
Console Screws (57). Make sure that the wires are |
not pinched. |
Snap the bookrack onto the Console (4) in the location |
shown. |
6 | 4 |
| |
| Bookrack |
| 77 |
| 98 |
| Console |
| Wires |
| Ground |
| Wires |
| 3 |
57 | Be careful to avoid |
pinching the wires |
during this step.
7.Make sure that all parts of the stepper are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the stepper.
6
