2.While another person lifts and holds the indicated end of the Frame (1), insert the Stabilizer (2) into the Frame. Attach the Stabilizer with four M10 x 25mm Button Screws (29) and four M10 Split Washers (30).
3.Slide one of the Pedal Brackets (13) onto the end of the Right Pedal Leg (10). Align the lower hole in the Pedal Bracket with the hole in the Lower Pedal Leg (12). Insert an M10 x 82mm Button Bolt (26) into the Pedal Bracket and the Lower Pedal Leg.
Next, align the upper hole in the Pedal Bracket (13) with the hole in the Right Pedal Leg (10). Insert an M10 x 82mm Button Bolt (26) into the Pedal Bracket and the Right Pedal Leg. Tighten an M10 Nylon Locknut (27) onto each of the Button Bolts.
Attach the other Pedal Bracket (13) in the same way.
4.While another person holds the Upright (3) near the Frame (1), connect the Extension Wire Harness (77) to the Wire Harness (39).
Gently pull the upper end of the Extension Wire Harness (77) out of the top of the Upright (3) to remove any slack. Then, carefully insert the Upright into the Frame (1). Attach the Upright with two M10 x 91mm Button Screws (63) and two M10 Split Washers (30).
2 |
|
|
1 |
| 2 |
30 |
|
|
29 |
|
|
3 |
| 26 |
10 |
| |
12 |
| |
27 | 13 | |
|
| |
|
| 13 |
4 |
|
|
|
| Be careful |
|
| to avoid |
|
| pinching the |
|
| Wire Harnesses |
|
| (39, 77) during |
|
| this step. |
|
| 3 |
|
| 77 |
|
| 39 |
| 1 | 30 |
|
| |
|
| 63 |
5
