NordicTrack NTCW90907.0 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included hex keys, assembly requires a Phillips screwdriver , an adjustable

wrench , and a rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.

M8 Nylon	M8 Split	M10 Split	M10 Washer	23mm x 19mm
Locknut (63)–4	Washer (80)–8	Washer (79)–10	(64)–4	Wave Washer
				(76)–4
M4 x 16mm	M4 x 16mm	M4 x 30mm	M6 x 13mm	M6 x 32mm Patch
Round Head	Screw (67)–9	Screw (74)–4	Patch Screw	Screw (96)–4
Screw (95)–4			(78)–8
M8 x 13mm	M8 x 25mm Flat	M8 x 45mm Button		M10 x 19mm Patch
Patch Screw	Patch Screw
		Bolt (70)–4		Screw (61)–14
(62)–8	(68)–6

5