NordicTrack NTEL12900 user manual Ing the wires, Center the Arm Axle

9. Remove the four Console Screws (35) and the four	9
Console Washers (101) from the Console (87).
			87
					Bookrack
Connect the console wire to the Extension Harness
(99).
Attach the Console (87) to the Upright (2) with the four		Console
		Wire
Console Screws (35) and the four Console Washers
(101) removed previously. Be careful to avoid pinch-			99
ing the wires.
Snap the bookrack onto the Console (87) where shown.			101		2
			35	35
10. Slide the Left Upper Body Arm (15), which is marked	10
with an “L” sticker, onto the Chrome Tube (98) on the
					18
Left Pedal Arm (3). Slide the Right Upper Body Arm
(18) onto the Chrome Tube on the Right Pedal Arm (4).
Make sure that the Upper Body Arms are on the
correct sides—the upper ends should bend in the
direction shown by the arrows. Next, slide an Axle					49
Cover (49) onto the post on each Upper Body Arm.
Apply grease to the Arm Axle (34). Insert the Arm Axle				34	51
				49	94
into the Upright (2), the right Pivot Cover (49), and the	15
Right Upper Body Arm (18) as shown. Push the Arm
					2
Axle into the Upright until the left end of the Axle is flush
				Grease
with the left side of the Upright. Next, raise the Left
Upper Body Arm (15) and insert the Arm Axle into the				Post
left Axle Cover (49) and the Left Upper Body Arm.		94
Center the Arm Axle.	51				98
Using the included pedal tool, tap two Push Nuts (94)				98	4
about 1/8” onto each end of the Arm Axle (34). Make
sure that the Push Nuts are turned as shown in the
inset drawing. Note: It may be helpful if another person
holds a block of wood against one end of the Arm Axle	Pedal Tool		94	34
while you tap Push Nuts onto the other end.
Press the two Axle Caps (51) onto the Arm Axle (34).				3

11.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.

8