7. Set the console assembly face down on a soft

7

 

 

 

surface to avoid scratching the console assem-

 

Console

 

 

 

 

bly. Hold the Right Handrail (95) near the con-

 

 

Wire

 

sole assembly. Next, insert the console wire into

 

 

 

 

the large hole in the Right Handrail and out of

95

1

Hole

 

the top as shown. If necessary, use needlenose

 

 

 

 

1

pliers to help pull the console wire out.

 

 

 

 

 

 

 

Attach the Right Handrail (95) and the Left

 

 

 

 

Handrail (not shown) with four #8 x 3/4" Screws

 

 

 

 

(1) (two are shown). Make sure that no wires

 

 

 

 

are pinched. Start all four Screws before

 

 

 

 

tightening any of them; do not overtighten

 

 

 

 

the Screws.

 

 

 

 

 

 

 

 

Console

 

 

 

 

Assembly

8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star

8

 

 

 

Washer (33) into the bracket and Handrail

 

 

 

 

 

 

 

Crossbar (94) on each side of the console as-

 

 

5

Wire

sembly (only one side is shown).

 

 

 

 

 

Tie

 

 

 

33

 

 

 

 

Remove the wire tie from the console wire.

 

 

 

 

 

Console

 

 

 

Assembly

94

 

 

 

9. Remove the long tie from the Upright Wire (38).

9

 

 

 

 

 

 

 

Have a second person hold the console assem-

 

Console

 

 

 

Assembly

 

 

bly near the Right Upright (78) and Left Upright

 

 

 

 

 

 

 

(not shown). Connect the Upright Wire (38) to

 

 

 

 

the console wire. See the inset drawing. The

 

 

 

 

connectors should slide together easily and

 

 

 

 

snap into place. If they do not, turn one connec-

 

 

 

 

tor and try again. IF THE CONNECTORS ARE

Console

 

 

NOT CONNECTED PROPERLY, THE CON-

 

 

Wire

 

 

SOLE MAY BE DAMAGED WHEN THE

 

 

 

 

 

 

POWER IS TURNED ON.

 

 

 

 

Attach the console assembly to the Right Upright

 

78

 

Console

(78) and Left Upright (not shown) with four 5/16"

 

38

Long

Wire

 

 

x 3 1/4" Bolts (7) and four 5/16" Star Washers

 

 

Tie

 

(10) (only two are shown). Be careful not to

 

10

 

 

pinch the wires.

 

 

 

 

 

 

38

 

7

 

 

See steps 4 and 6. Tighten the four 3/8” x 5”

 

 

 

 

 

 

 

Bolts (6).

 

 

 

 

 

9

 

 

 

Page 9
Image 9
NordicTrack NTL07707.2 Tor and try again. if the Connectors are, Not Connected PROPERLY, the CON, Pinch the wires