1.Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (56) so that the treadmill is more stable; do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A) and the shipping bracket (B).
Cut the ties securing the Upright Wire (38) to the Base (83). Locate the tie in the indicated hole in the Base, and use the tie to pull the Upright Wire out of the hole.
Attach a Base Pad (81) to the Base (83) in the location shown with a Base Pad Spacer (13) and a #8 x 1" Tek Screw (2). Then, attach another Base Pad (81) with only a #8 x 1" Tek Screw (2).
2.Remove the 3/8" Nut (8), the 3/8" x 2" Shoulder Bolt (113), and the shipping bracket (C) from the Base (83). Attach a Wheel (84) with the Bolt and the Nut that you just removed. Do not over- tighten the Nut; the Wheel must turn freely. Discard the shipping bracket.
3. Identify the Right Upright (78) and the Right |
Upright Spacer (79), which are marked with |
stickers. Insert the Upright Wire (38) through the |
Right Upright Spacer as shown. |
1 |
|
|
|
| B | A | 83 |
|
| ||
Hole |
|
|
|
38 |
|
| 81 |
Tie |
|
| 2 |
13 | 81 |
|
|
56 | 2 |
|
|
|
|
| |
2 |
|
|
|
| 83 |
|
|
113 |
|
|
|
| 84 |
|
|
C |
|
|
|
8 |
|
|
|
3 |
|
|
|
38 | 78 |
|
|
|
|
|
See the inset drawing. Tie the long tie in the |
Right Upright (78) securely around the end of |
the Upright Wire (38). With the help of a second |
person, hold the Right Upright near the Base |
(83). Then, pull the other end of the long tie until |
the Upright Wire is routed completely through |
the Right Upright. |
Long Tie
38
79
| 78 |
38 | Long |
| |
| Tie |
83
7
