5.Identify the Latch Assembly (76). Remove the tie from the end of the tube. Make sure that the sleeve has been slid over the indicated hole and that the Latch Knob (50) is locked into the hole.
Pull on the sleeve to make sure that it is locked into place.
6.Raise the Frame (55) to the position shown.
Have a second person hold the Frame until this step is completed.
Orient the Latch Assembly (76) so that the large barrel and the Latch Knob (50) are in the posi- tions shown.
Attach the Latch Assembly (76) to the Uprights
(85)with a 3/8" x 2" Bolt (109) and a 3/8" Nut
Attach the upper end of the Latch Assembly (76) to the bracket on the Frame (55) with a 3/8" x 2" Bolt (109) and a 3/8" Nut (20). Note: It may be necessary to move the Frame back and forth to align the Latch Assembly with the bracket.
Lower the Frame (55) (see HOW TO LOWER THE TREADMILL FOR USE on page 28).
7.Identify the Left Base Cover (88), which has cutouts in the locations shown. Slide the Left Base Cover onto the left Upright (85). Then, slide the Right Base Cover (86) onto the right Upright.
Identify the Left Upright Sleeve (77) and the Right Upright Sleeve (9). Slide the Upright Sleeves onto the Uprights (85) as shown.
5 |
|
|
|
|
| 50 |
|
Tube |
| Hole | |
|
| Sleeve |
|
|
|
| 76 |
6 |
|
|
|
|
| 55 |
|
| 20 | 109 |
|
|
|
| |
|
| 76 |
|
| 50 |
|
|
|
| Large |
|
|
| Barrel |
|
|
| 85 |
|
| 20 |
| |
|
| 109 |
|
7 |
| 85 |
|
|
|
| |
|
| 77 |
|
Cutouts |
| 88 | 9 |
|
| 86 |
|
9 |
|
|
|
