ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly can be completed using the included hex keys.
Note: The underside of the treadmill walking belt is coated with
1.Slide the Right and Left Uprights (95, 97) onto the brack- ets near the front of the Frame (76). Make sure that the
Uprights are on the correct sides; the indicated holes must be facing inward.
Raise the Right Upright (95) until the lower hole in the front of the Right Upright is aligned with the upper hole in the bracket on the Frame (76). Finger tighten an Upright Bolt (96) into the Right Upright and the bracket. Do not tighten the Upright Bolt yet.
Repeat this step with the Left Upright (97).
2.While a second person holds the Handrail (91) near the Uprights (95, 97), feed the Power Wire Harness (57) in the right Handrail down into the right Upright. Pull the end of the Power Wire Harness out of the lower end of the right Upright. If there is a wire tie on the end of the Power Wire Harness, remove it. Then, set the Handrail on the Uprights.
Finger tighten eight Handrail Bolts (99) into the Uprights (95, 97) and the Handrail (91). Do not tighten the
Handrail Bolts yet. Be careful to avoid pinching the Power Wire Harness (57).
Note: The CD Holder (86) and the Cup Holder (85) are replaceable. If these parts become dislodged from the Console Base (89), simply press them back in.
3.Connect the Power Wire Harness (57) in the indicated lo- cation. Push all of the excess wire up into the right Upright (95). Make sure that the Wire Harness is fully connected.
1 | Holes |
|
|
|
|
|
| 95 | |
| 96 |
|
| |
|
|
|
| |
|
|
|
| 96 |
97 |
|
|
|
|
|
|
|
| 76 |
2 |
|
|
|
|
|
|
|
| 89 |
| 86 |
|
|
|
| 99 |
|
|
|
91 |
|
|
|
|
|
| 99 |
| 85 |
|
|
|
| |
|
|
|
| 99 |
| 97 |
| 57 | 95 |
|
|
| ||
3 |
|
|
| 95 |
|
|
|
| 57 |
6
