7.SYMPTOM: THE SURFACE OF THE WALKING PLATFORM IS DAMAGED
a.Both sides of the walking platform are designed to be used as walking surfaces. If the surface becomes damaged, or if there is any wood showing through the coating, the walking platform can be turned over. The walking platform typically needs to be turned over after approximately 6,000 to 7,500 miles. Follow the in- structions below to turn over the walking platform.
Remove the key and unplug |
|
|
|
|
the power cord. Remove the |
|
| 1 | 2 |
two Hood Screws (2) and lift off |
|
|
|
|
the Motor Hood (1). Next, re- |
|
|
|
|
move the two Rear Roller Bolts |
| 80 |
|
|
(82), the two Roller Guard |
|
| 6 | |
83 | 6 |
| ||
Screws (80), and the Right and |
|
| ||
|
|
|
| |
Left Roller Guards (81, 83). | 82 |
| 70 |
|
|
|
| ||
|
|
|
| |
Remove the six Platform |
|
| 80 |
|
|
|
|
| |
Screws (6). Lift the Rear Roller |
| 81 | 6 |
|
(79) and slide it out of the |
| 82 |
|
|
Walking Belt (71). Lift the |
|
|
| |
|
|
|
| |
Walking Platform (70) a few |
| 71 |
|
|
inches, slide it out of the |
|
|
| |
| 79 |
|
| |
Walking Belt, turn it over, and |
|
|
| |
then slide it back into the |
|
|
|
|
Walking Belt. Slide the Rear |
|
|
|
|
Roller back into the Walking |
|
|
|
|
Belt. Reattach the six Platform Screws (6). Reattach the Right and Left Roller Guards (81, 83) with the two Roller Guard Screws (80). Insert the Rear Roller Bolts (82) into the Roller Guards and thread them into the Rear Roller (79). Reattach the Motor Hood (1) with the two Hood Screws (2).
Next, the Walking Belt (71) will need to be adjusted to the proper tension. Using chalk, make two marks exactly 50” apart on the Walking Belt as shown in the drawing. Then, tighten both Rear Roller Bolts (82) until the two chalk marks move apart an additional 3/16” to 1/4”. Make sure to keep the Walking Belt centered.
71 |
50” |
82 |
26
