38.Attach the Seat (14) to the Seat Frame (9) with two M6 x 50mm Button Head Screws (91) and an M6 x 63mm Button Head Screw (92).
39.Attach the Right Leg Pad (19) to the Leg Developer Plate (18) with two M8 x 19mm Button Head Bolts (88).
Attach the Left Leg Pad (20) in the same man- ner.
40.Attach a Leg Developer Strap (43) to the Leg Developer (10) with an M8 x 12.5mm Button Head Shoulder Screw (83).
Attach the other Leg Developer Strap (43) in the same manner.
38 |
|
14 |
|
| 9 |
91 |
|
| 92 |
91 |
|
39 |
|
19 |
|
88 |
|
18 |
|
20 |
|
40 |
|
10 | 43 |
| 83 |
41.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on page 21 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING AND MAINTENANCE on page 20.
16
