NordicTrack NTS79020 user manual Hole Guide Numbers Reverse View

4.Attach the Backrest Frame (6) to the Base (1) with two M10 x 82mm Button Head Bolts (74) and two M10 Nylon Locknuts (101). Do not tighten the Locknuts yet.

Note: The Press Arms (11, 12) are preassem- bled in the down position (see part 12). Throughout this manual the Arms are shown in the raised position (see part 11). It is not necessary to raise the Arms for assembly.

5.Attach the two Weight Guides (21) to the Weight Base (2) with two M10 x 92mm Button Head Bolts (90), four M10 Washers (98), and two M10 Nylon Locknuts (101).

Slide two Weight Bumpers (66) onto the Weight Guides (21). Starting with the Large Weight (23) marked “400”, slide the fifteen Large Weights and the nine Small Weights (22) onto the Weight Guides. Make sure the Weights are stacked so the numbers are in order and on the indicated side.

Grease the guide holes in the Top Weight (27) with grease. Slide the Top Weight onto the Weight Guides (21). Make sure the Top Weight is ori- ented with the hole on the indicated side.

See the inset drawing, shown from the reverse side of the system for clarity. Attach the tether on the Weight Pin w/tether (67) to the hole in the Top Weight (27) with an M8 x 19mm Button Head Bolt (88). Insert the Weight Pin into the stack of Weights (23).

7

4
11
	6	12
		101
		101
		1
	74
5		27
21		Hole
Hole		23	88
27	Guide		67
	Hole
Numbers		Reverse View
22
23
	66
66	98
	90
101	98
	2
98
90