Installing a Module
For details about the operation of modules, refer to the documentation that was shipped with each module.
Required tool: Phillips screwdriver
9058FA | 9059FA |
1.Remove a filler panel from a module slot.
2.Make sure the inserter/extractor levers are rotated away from the front of the module.
9060FA | 9070FA |
3.Align the module circuit board with the card guides in the chassis. Slide the module into a slot in the chassis until the module touches the backplane connectors.
4.Rotate the inserter/extractor levers to seat the backplane connectors.
9
