Nortel Networks MCP 1.1 FP1(02.02) manual Default gateways are for the cards, not for the host

Nortel Networks Confidential Configuration management 35

Table 2 RTP Media Portal tab configurable properties

Major Port Usage Alarm Level

Critical Port Usage Alarm Level

Private Netmask

Type: Percent

Range: 0-100

Default: 80

Type: Percent

Range: 0-100

Default: 90

Type: IP address

Range: N/A

Default:

255.255.255.0

(Default gateways are for the cards, not for the host.)

The percent usage at which the number of ports used on the public or private side of an RTP Media Portal (over all blades) causes a major alarm.

The percent usage at which the number of ports used on the public or private side of an RTP Media Portal (over all blades) causes a critical alarm.

The Private Network Mask is used for routing on the Private network.

Public Netmask	Type: IP address
	Range: N/A
	Default:
	255.255.255.0
	(Default gateways
	are for the cards,
	not for the host.)
Default Gateway	Type: IP Address
	Range: N/A
	Default: 0.0.0.0

The Public Network Mask is used for routing on the Public network.

The Default Gateway is the gateway router to the rest of the world (the default route).

Note: If this value is not filled in, the RTP Media Portal will fail to provide service. The RTP Media Portal will not provide service unless the blades can communicate with the specified Default Gateway.

Copyright © 2003, Nortel Networks MCP RTP Media Portal Basics