Nortel Networks NN46120-104 manual Setting Up a Two-Armed Configuration

44Initial Setup

Complete the new setup by following the instructions in the section “Complete the New Setup” (page 46).

--End--

Setting Up a Two-Armed Configuration

In a two-armed configuration, two separate interfaces are configured on the VPN Gateway, one private interface for NVG management and intranet connections and one public interface for Internet connections. Also see figure on “Two-Armed Configuration” (page 39).

Step	Action
1	Choose new from the Setup menu.
	[Setup Menu]
	join	- Join an existing iSD cluster
	new	- Initialize iSD as a new installation
	boot	- Boot menu
	info	- Information menu
	exit	- Exit	[global command, always
	available]
	>> Setup# new
	Setup will guide you through the initial configuration
	of the iSD.
2	Configure the management interface port number.
	Enter port number for the management interface [1-4]: 1
	Specify the port you want to use for NVG management and other
	private traffic between the VPN Gateway and the intranet. This
	port will be assigned to the private interface (Interface 1).
3	Specify the host IP address for the current VPN Gateway.
	Enter IP address for this machine (on management
	interface): <IP address>
	Specify a host IP address on the management (private) interface.
	This IP address must be unique on the network and be within
	the same network address range as the Management IP address
	(see Step 10). The management interface host IP address is
	assigned to Interface 1.
4	Enter network mask and VLAN tag ID.
	Nortel VPN Gateway
		User Guide
	NN46120-104 02.01		Standard
		14 April 2008

Copyright © 2007-2008 Nortel Networks