Displaying Pictures with the Projector (Projector Mode)

CBuilt-in Projector Stand

•The built-in projector stand allows the camera to be tilted slightly upward so that the projected picture is not obstructed by the surface of the table on which the camera is placed.

•Slide the projector stand latch (1) and push (2) to

raise it. To lower the projector stand, slide the projector stand latch (3) and push (4) it into the camera.

• When the projector stand is used, the picture is projected onto the screen at an angle, resulting in a type of distortion known as the keystone effect. Using a tripod instead of the built-in projector stand makes it easier to properly align the camera with the screen, reducing the keystone effect.

CAuto Power Off with Projection

When no operations are performed during projection, the camera ends projection to save power and enter standby mode, and the power-on lamp blinks. If another three minutes passes in standby mode, the camera turns off.

•While the power-on lamp is blinking, press the buttons indicated below to reactivate the monitor in shooting or playback mode.

-Playback mode: power switch, shutter-release button, or cbutton

-Shooting mode: A button

•To resume projection, press the Pbutton again in playback mode or shooting mode.

•The time allowed to pass before the camera enters standby mode when no operations are performed during projection can be changed from Auto off (A173) in the projector settings menu (A 172).

CProjection Distance and Projected Picture Size

Projection distance

Projected picture size

26 cm (10 in.)

Approx. 10 × 7.5 cm (4 × 3 in.; equivalent to 5-inch display)

50 cm (1 ft. 7 in.)

Approx. 20 × 15 cm (8 × 6 in.; equivalent to 10-inch display)

1.0 m (3 ft. 3 in.)

Approx. 40 × 30 cm (16 × 12 in.; equivalent to 20-inch display)

1.5 m (4 ft. 11 in.)

Approx. 60 × 45 cm (24 × 18 in.; equivalent to 30-inch display)

2.4 m (7 ft. 10 in.)

Approx. 94 × 70 cm (37 × 28 in.; equivalent to 47-inch display)

projector the Using

165