10.Use compressed air only. Clean, dry, regulated compressed air at 90 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.
11.Always disconnect air supply when this tool is not being used.
NOTE: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors that cannot be built into this product but must be supplied by the operator.
NOTE: READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
OPERATION
Set Up
Fig. 1
!WARNING!
This impact wrench supplies powerful torque and it designed to be operated with two hands. Failure to operate the Impact wrench with two hands may result in serious injury.
1.You will need to prepare a 1/4" air connector (not included) to connect to the air inlet on the tool. First, wrap the 1/4" air connector with pipe thread seal tape (not included) before threading it into the inlet. Connect the 3/8" ID air source hose (not included) to a
2.Set the air pressure on your compressor to 90 PSI. Do not exceed the recommended air pressure of 90 PSI.
3.Check the air connection for leaks.
4.Disconnect from the air hose until next instructed to reconnect.
Note: Turn off your air compressor and disconnect the air hose when you are changing sockets. After you attach the socket (not included), attach the air hose and turn the air compressor on.
i.Select the appropriate size 1/2" socket for your needs.
ii.Push and snap the socket onto the anvil.
iii.Tightening
The max. working torque of the impact wrench is
115
2 of 4
