Sherwood R-963 manual Setting the ROOM2 Feed Setup, When selecting the Volume Mode

SETTING THE ROOM2 FEED SETUP

ENGLISH

R O O M 2 F E E D S E T U P

V O L U M E M O D E

F U N C T I O N S E L E C T

R E T U R N : B a c k E N T E R : S e l e c t

To select the desired volume mode. To select the desired ROOM 2 source.

The ROOM 2 function allows enjoying one source in the main room while playing another in a different room at the same time.

The analog signals from the 7.1 CH DIRECT inputs and TAPE MONITOR INs as well as the digital signals from the coaxial or optical digital input cannot be output from the ROOM 2 OUTs.

When selecting the VOLUME MODE

1	Press the CURSOR UP( )/DOWN( ) buttons to select the VOLUME MODE, then press the ENTER
	button.	OSD
		OFF
						V O L U M E M O D E
		PAGE	MAIN	FAV
		VOL		CH		V O L U M E M O D E	: Variable
		1	2	3
		4	5	6		R E T U R N : B a c k	, : S e l e c t
		7	8	9
			0
		MI	M2	M3
		RNC-500
2	Press the CURSOR LEFT( )/RIGHT( ) buttons to select the desired volume mode for the ROOM 2
	source.					Each time these buttons are pressed, the volume mode
		OSD				changes as follows:
		OFF
						Variable : Select this when an power amplifier is connected
		PAGE			FAV	to the ROOM 2(audio) OUTs for ROOM 2 source
			MAIN			playback. You can adjust the ROOM 2 volume
		VOL			CH
						level with the MASTER VOLUME CONTROL
		1	2		3	knob of this receiver or the VOLUME
						UP/DOWN buttons on the remote control.
		4	8		6
			5
		7			9
			0			Fixed : Select this when an integrated amplifier, etc. is
		MI	M2		M3

RNC-500

connected to the ROOM 2(audio) OUTs. You can adjust the ROOM 2 volume level on the connected

integrated amplifier, etc.

Notes :

When you assign the power amplifier for the surround back channels to the ROOM 2, the volume mode is automatically set to Variable.

In case that an integrated amplifier, etc. is connected to the ROOM 2(audio) OUTs and the volume mode is set to Variable, if the ROOM 2 volume level is adjusted to high level on both this receiver and the connected amplifier, the ROOM 2 speaker and the connected amplifier may be damaged.

Therefore, be sure to set the volume mode to Fixed for safe operation when using amplifier or receiver with its own volume control for ROOM 2.

When selecting the Fixed mode, first adjust the volume level as desired in the Variable mode and select the Fixed mode. Then the volume level will be fixed to the adjusted level.

50