Sherwood R-963 manual Correcting or clearing a video label

Entering a video label				2	Press the VIDEO LABEL button to enter the
					video label mode.
This function can be operated only on video input					Example) When selecting VIDEO 1.
sources such as VIDEO 1~5.
1	Select the desired video input source to				VIDEO LABEL
	enter its label.
		OSD	POWER
	VIDEO	OFF
		or

3	Select the character on the flickering digit.	4	Confirm your selection.
	MULTI CONTROL		VIDEO LABEL

		Then the next digit will flicker.
Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
		5	Repeat the above steps and to enter
Blank (	)		the desired characters on the rest of the
Alphabets: A~Z, a~z			digits.
Numerals: 0~9		On up to 9 digits, the desired characters can be entered.
		Note: If any button such as “AUDIO”, “VIDEO”, “7.1
			CH DIRECT” button, etc. is pressed while
Symbols:			entering a video label, the video label mode will
			be canceled.

MEMO/ENTER

Memorize the desired video label.

6

ENGLISH

Correcting or clearing a video label

Select the desired video input source to be

1 rectified or cleared.

OSD POWER

VIDEOOFF

or

2	Repeat the steps ~ in “Entering a
	video label” procedure.

To clear a video label, make a blank on each digit and memorize it, then the video label is cleared and its factory video input source will be displayed.

If the VIDEO LABEL button is pressed for more than 3 seconds, blanks will be made on all the digits at once.

33