Sherwood R-963 manual Adjusting each channel level with test tone

ENGLISH

Adjusting each channel level

If you have performed the CH LEVEL TRIM procedure on the OSD menu, you can skip this procedure. (For details, refer to “SETTING THE CH LEVEL TRIM” on page 49.)

Select the desired channel.

3	OSD
	OFF
CHANNEL
SELECTOR	PAGE	MAIN	FAV	CH/
	VOL		CH	SET
	or

1 2 3

4 5 6

7 8 9

0

MI M2 M3

RNC-500

Each time this button is pressed, the corresponding channel is selected and displayed for 3 seconds as follows:

FRONT-L CENTER(or FRONT-C) FRONT-R SURR-R SUBWOOFER SURR-L(( SURR-C) or ( BACK-L BACK-R))

Depending on the speaker setting, items set to None or No cannot be selected.

Adjusting each channel level with test tone

Only when playing a program source in available surround modes except the DOLBY VIRTUAL mode, the volume level of each channel can be adjusted easily with the test tone function.

Note: When the 7.1 CH DIRECT is selected as an input source, the test tone function does not work.

Enter the test tone mode.

6

OSD	POWER
OFF

TEST TONE

or

The test tone will be heard from the speaker of each channel for 2 seconds as follows:

Front Left Center		Front Right Surround Right
	Surround Left ((	Surround Center) or ( Back Left Back Right))
	SUBwoofer

Depending on the speaker setting(None or No), the test tone of the corresponding channel is not available.

Adjust the level of the selected channel

4	as desired.
		OSD
		OFF
	MULTI CONTROL
		PAGE	MAIN	FAV
		VOL		CH	CH
		or
		1	2	3
DOWN	UP	4	5	6
		7	8	9
			0
		MI	M2	M3
			RNC-500

If the channel display disappears, start from the

above step again.

5	Repeat the above steps	and	to
	adjust each channel level until the sound
	level of each speaker is heard to be

equally loud.

At each channel, adjust the level as

7 desired until the sound level of each speaker is heard to be equally loud.

		OSD
		OFF
	MULTI CONTROL
		PAGE	MAIN	FAV
		VOL		CH	CH
		or
		1	2	3
DOWN	UP	4	5	6
		7	8	9
			0
		MI	M2	M3
			RNC-500

You can select the desired channel and adjust its level with repeating the steps and in “Adjusting each channel level” procedure.

Cancel the test tone function.

8

OSD	POWER
OFF

TEST TONE

or

26