Sherwood R-963 manual Digital Audio Recording with MD Recorder, Input is selected as follows

Start recording on the component hooked

3 up to the VIDEO 1.

Start play on the components hooked up to

4 the VIDEO 2 and the CD respectively.

The audio signal from the CD and the video signal from the VIDEO 2 component will be dubbed and you can enjoy them on the TV set and from the speakers.

Note : Be sure to observe the order of the above steps and .

ENGLISH

DIGITAL AUDIO RECORDING WITH MD RECORDER

Only when the OPTICAL DIGITAL OUT of this receiver is connected to the OPTICAL DIGITAL IN of the MD recorder or CD recorder, you can enjoy high-quality sound of digital recording without converting the original signals. Refer to “ CONNECTING AUDIO COMPONENTS” and “CONNECTING DIGITAL INs and OUT” on page 5 and 7 and the operating instructions of the MD recorder or CD recorder.

Notes:

Digital recording is available for the digital audio program sources such as CDs, MDs, some DVDs, etc. In most DVDs as well as some CDs, etc., digital recording may not be available depending on the signal format.

There are some restrictions on recording digital signals. When making digital recordings, refer to the operating instructions of your digital recording equipment to know what restrictions are imposed.

1	Select a desired input of CD, TAPE			2	For digital recording, select the desired
	MONITOR and VIDEO 1~VIDEO 5 as a				digital input as the recording signal input.
	recording source.
				DIGITAL/ANALOG		OSD	POWER
						OFF
		OSD	POWER
	INPUT SELECTOR	OFF				or
AUDIO	VIDEO TAPE MON.
	or
				Each time this button is pressed, the corresponding
				input is selected as follows:
				DIGITAL		ANALOG
				Note : When the selected digital input is not
					connected, “DIGITAL” is flickering. There
					will be no recording as well as no sound.
3	Start recording on the component			4	Start play on the desired input.
	connected to OPTICAL DIGITAL OUT.

31