To overlay the radar:
1.Display the Chart screen.
2.Select Chart Overlays. The Radar Overlay button shows the current setting. Select the button if you want to toggle to the other setting. If it's:
On, the Radar screen overlay is operational. If no Radar screen is
shown, the radar mode may be set to Off or StandBy. (To check this, select Radar Settings, and the Radar Mode button will show the status. To start the radar, select Radar Mode, then
Transmit.)
Off, the Radar screen overlay is not shown.
3.The new setting is applied immediately and stays until you change it again.
4.When you are finished, select Return.
3.10Create a waypoint
You can create a waypoint anywhere on the Chart screen (except the shaded frame around the edge).
To create a waypoint:
1.Display the Chart screen and the control panel.
2.Select the position on the chart where you want the new waypoint, then select Create Waypoint Here
3.The 8000i immediately creates the new waypoint and displays the Waypoint Details box with some details (such as the latitude and longitude of the waypoint) already entered.
4.Use the Waypoint Details information box to add or change the information,
5.When you are finished, select Return. If you have used the Waypoint Details information box to change any of the details, the new waypoint is stored in the Waypoint Library and is shown on the Chart screen with a red circle around it.
3.11Create an event mark
An event mark is a waypoint at your vessel's current position.
To create an event mark:
1.Display the Chart screen and the control panel. Then select the MARK key.
2.The 8000i immediately creates an event mark at your vessel's current position.
3.To display details about the event mark, (such as the latitude and longitude) select the event mark then select Waypoint Details.
Northstar 8000i Quickstart Guide | 25 |
