NovaJet PRO 600e
Paper axis calibration
Choosing Utility/Calibration/Paper Axis Test lets the printer draw a set of vertical marks to calibrate the paper axis. To measure the marks laid down by the printer, you will need a ruler or scale at least 33 inches (838.2 mm) long. The vertical marks should be exactly
33.00 inches (838.2 mm) apart. If the distance between the marks is different from that shown on the display, you may adjust the printer by setting its values to match the length or width you measured. Note: The Paper Axis Test should be performed every time new media is loaded.
➪To print the Paper Axis calibration test pattern
1Load the printer with media that is at least 36 (91 cm) inches long (or the media that you are going to run; you cannot load a 36" sheet and then run the calibration from a roll feed because the line lengths will not match).
2Press Utility/Calibration/Paper Axis Test. The printer prints two marks.
3Remove the media from the printer and measure the distance between the marks. The distance between the marks should be exactly 33.00 inches (838.2 mm).
4If the measurement is not exactly 33.00 inches, select "Paper Axis" and adjust the value to the measurement read on the scale.
22 Quick Start
