NuTone CT650 operating instructions HOW to USE the Power Brush, Maintaining Power Brush

Pile Height Pedal

HOW TO USE THE POWER BRUSH

NOTE:

The Power Brush is not recommended for use on bare floors. Wand release on Power Brush allows you to quickly disconnect wands and switch to Combination Floor/Rug Tool for use on bare floors.

Always pick up hard or sharp objects by hand before using your Power Brush. Items such as pins, hairpins, tacks, crayons and pencil stubs may damage the brush roll or may break a belt.

HANDLE RELEASE		Pile
		Height
Push down on Power Brush handle release		Indicator
pedal; pull wand/hose assembly back to com-
fortable work position. Return the handle to
the upright position for storage.
	Handle
HEIGHT ADJUSTMENT	Release
	Pedal

Select height setting by depressing height

adjustment pedal to desired position: Extra-Low, Low, Medium or High.

EDGE CLEANER

Brush extends full width for effective edge cleaning along both sides of nozzle. To operate, simply run cleaner along edge board. Rubber bumper protects furniture and baseboards.

MAINTAINING POWER BRUSH

NOTE: Disconnect power cord and wands from electrical hose before clean- ing Power Brush.

5. Alignez le
devant du		7. Rabaissez le couvercle et
couvercle
et le socle.		appuyez ferme-
Déposez		ment dessus
le couver-		jusqu’à ce que
cle sur l’a-		les agrafes
vant du		latérales
Couvercle	Socle	arrière s’en-
socle,
comme illustré.		cliquent.
		Tournez le
		balai motorisé à l’envers et
		remettez en place les deux
		vis du couvercle.

6.NOTE: Sur les modèles dotés d’un capteur de saleté, assurez- vous que la carte est à la verticale et que les fils sont bien repliés, comme illustré.

REMPLACEMENT DE L’AMPOULE

The instructions given in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the belt and brush roll often. Replace the belt if it is stretched or cracked. Clean the brush roll bristles when they are wrapped with thread and hair. Build-up could cause the brush to rotate unevenly.

GENERAL CARE

To keep the Power Brush housing clean, it can be wiped with a damp cloth and a mild soap solution, then thoroughly dried. Never use any type of chemical as chemicals can damage the housing. When not in use, the Power Brush should be stored in a clean, dry place.

The motor is permanently lubricated and sealed. Do not oil the motor at any time.

1.Retirez le couvercle comme indiqué à la section REMPLACEMENT DE LA COURROIE ET NETTOYAGE DE LA BROSSE.

Pousser et

tourner2. Poussez sur l’ampoule et faites-la tourner dans le sens anti- horaire, puis tirez dessus pour l’enlever.

3. Insérez l’am-

Pousser etpoule, poussez

tourner

dessus puis faites-la tourner dans le sens horaire. L’ampoule ne

doit pas être d’une puissance supérieure à 130 V / 15 W.

4.Replacer le couvercle sur le balai motorisé, comme illustré à la page 10. NOTE: Utilisez une ampoule numéro 9123A.

6 11