10.Hold the new memory board by its short edges, so that the edge connector faces in towards the RAM expansion slot, and the small cutout is closer to the bottom of the printer.
11.Gently push the board into the RAM expansion slot until it latches in and will not go any further.
12.Locate the three retaining clips at the bottom of the side cover into their rectangular holes near the bottom of the printer.
13.Close the top of the side cover up to the printer and refit the securing screw removed in step 4.
14.Close the front cover and close the top cover, pressing down firmly at each side to latch it closed.
15.Reconnect the AC power cable and switch the printer on.
16.When the printer is ready, print a menu map as follows:
(a)Press the + button to access the Information Menu.
(b)Press ENTER once for the menu map.
(c)Press ENTER again to print the menu map.
(d)When the menu map is printed, press ON LINE to exit the menu system.
17.Examine the first page of the menu map.
Near the top of the page, between the two horizontal lines, you will see the current printer configuration. This list contains the figure for total memory size.
This should indicate the total memory now installed, which should be the size of memory board you have installed plus 32MB.
