EN 12

En
Connecting the underwater optical fiber cableRemoving the TTL connector cap
To perform TTL flash shooting by connecting the separately available underwater flash or other products
to the Case using the underwater TTL cable (optional), remove the TTL connector cap as described
below.

How to attach the TTL connector cap to the case

Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL cable
connector. To secure the cap, gently turn it clockwise until it stops.
To connect the separately available UFL-2 underwater
flash to the Case using an underwater optical fiber cable
(optional), follow the procedures below.
• Remove the cap of the optical fiber cable insertion slot.
• Put the underwater optical fiber cable plug all the way
into the optical fiber cable insertion slot.
1Remove the TTL connector cap from
the Case.
2Connect the underwater TTL cable
(optional) to the TTL connector on the
Case.
CAUTION:
If the TTL connector cap is loose, water penetration may result. Be sure t o gently turn the cap until it stops to
make sure it is firmly secured.
Do not turn or tighten the TTL cable too hard. If it is too tight, it may be difficult to loo sen and remove.
1Turn counter
clockwise.
TTL connector cap 2Remove.
Underwater TTL
cable
Use this mark to
align the position.
3Insert into the
connector.
4Turn the threaded
section of the
connector clockwise
lightly until it stops.
Check O-rings
Cap Connector
2Gently turn the cap
clockwise until it
stops.
1Attach the cap to
the case.
PT-E05_EN.Book Page 12 Tuesday, June 17, 2008 11:11 AM