EN 20

En
Using the electronic flash with the TTL cable
To attach the Electronic Flash to this Case using TTL ca ble , connect the hot shoe cable to the camera
and to the hot shoe cable connector on the front lid side of this Case as described below. Note that the
camera’s built-in flash cannot be used when an external electronic f la sh and c a se ar e i nsta lled. Be sure
to set the automatic pop-up setting of the camera to OFF so that the builtin flash will not pop up
automatically.
2Set the automatic pop-up setting of the camera to OFF. The camera’s built-in flash is designed to po p
up automatically when shooting under low light or against backlight in any scene mode other than the
AUTO or underwater modes. This setting change is required to prevent this.
MENU X [Y]X [f] FLASHX [AUTO POP UP]
[OFF]: The built-in flash will not pop up automatically.
3Switch the electronic flash ON before switching the camera ON.
When using the electronic flash, be sure to turn it ON before turning the camera on.
Otherwise, if the automatic pop-up setting of the camera is ON and t he camera is set t o a scene mode
other than the AUTO or underwater modes, turning the camera ON before turning the electronic
flash on would cause the camera’s built-in flash to pop up automatically. Always be sure to turn the
electronic flash ON before turning the camera ON.
1Before loading the camera in the Case, connect the
hot shoe cable’s connector to the Case’s hot shoe
cable connector.
4Load the camera in the Case, and then
connect the hot shoe cable to the
camera.
CAUTION:
For details on camera function setup, refer to the ca mera’s instruction manual.
If the camera’s built-in flash pops up while the hot shoe cable is connected to the camera, it will interfere
with the hot shoe cable, either disconnecting it or causing a connection failu re.
When using a slave-type underwater flash from a no n-Olympus manufacturer, pop the camera’s built-in
flash up before loading it in the Case.
Once the camera has been loaded in the Case and the Case has be en sealed by closing the slide lock and
open/close dial it is no longer possible to pop up or retract the camera’s built-in flash.
When using an optional electronic flash with underwate r case, a bracket is required to attach the electronic
flash case to this Case.
PT-E05_EN.Book Page 20 Tuesday, June 17, 2008 11:11 AM