Omega OMA-P1104 82, Problem Solution, Communications / Dial-out:, Cause

Omegaphone® OMA-P1104 User’s Manual
82
Communications / Dial-out:
Problem Solution
Cause
6. The OMA-P1104 and telephone
answering device (sharing the
same line) answer incoming calls
simultaneously.
The OMA-P1104’s number of Rings Until
Answer is set to equal the number of rings
set for the telephone answering device.
Change the number of Rings Until Answer
for the OMA-P1104. Refer to Chapter 4,
Section 4.5.
5. The OMA-P1104 dials out
correctly but fails to audibly recite
its alarm message when you
answer the call.
Voice Reps is set to zero. Reprogram Voice Reps to 1 or greater.
Refer to Chapter 4, Section 4.10.
4. The OMA-P1104 recites the alarm
message or Status Report over the
telephone, but is silent at the
installation site.
The local voice mute feature is in effect. Deactivate local voice mute. Refer to the
programming steps in Chapter 4,
Section 4.9.
When calling the OMA-P1104, and the TAD
is disabled, allow the telephone to ring 10
times. Refer to Chapter 6, Section 6.1.3,
and Chapter 4, Section 4.6.3.
You did not allow the telephone to ring
10 times. Note: If theTAD (telephone
answering device) is disabled, the telephone
rings ten times before the OMA-P1104
answers. If the TAD is enabled, the
telephone rings once before the OMA-
P1104 answers the call.
3. The OMA-P1104 will not answer
the telephone for Callback
Acknowledgement.
(Continued from previous page)