Omega Engineering M-4066 manual Dual Discrete Output OUTPUTDISCn, Omwt-Dualout

Dual Discrete Output: OUTPUTDISCn

(OMWT-DUALOUT)

online (R) - indicates if the device is communicating (0 or 1) polltime (R/W) - how often to poll the device (in milliseconds) nodaladdress (R/W) – (TCP/IP Receiver). The node address starts at 1.

For TCP/IP Receivers, the node address corresponds to the node number for the TCP/IP connection. You can write to this parameter to determine which node to send the output packet. (write 0 and OMWT- SOFT-OPC will send to all nodes)

repeateraddress (R) – (Wireless mode) contains the location identifier of the OMWT-REPEAT Repeater. If the sensor did not pass through a repeater then the value is 0.

serialno (R) - registration number of the access/control reader updatecount (R/W) – value is incremented whenever the sensor is updated. outputa (R/W) – set to 0 or 1. Packet will be sent if TriggerOnB=0 option

is set in the INI file.

outputb (R/W) – set to 0 or 1. Packet will be sent when written. out.status (R) – 1 – OMWT-SOFT-OPC is in the process of sending output

packets based on tries and interval; 0 – OMWT-SOFT-OPC has finished sending the output packet.

out.interval (R/W) – time in milliseconds between OMWT-SOFT-OPC sending the output packet.

out.tries (R/W) – the number of times OMWT-SOFT-OPC will send the output packet. “-1” – never stops sending packets.

out.service (W) – When written to, OMWT-SOFT-OPC sends output packets to the output device for training.

Note: when either outputa or outputb is written to, OMWT-SOFT-OPC will send out output packets based on outtries and outinterval. It first sets outservice to 1, and then to 0 when finished.

(R) – indicates that the tag is readable.

(W) – indicates that the tag is writeable only.

(R/W) – indicates that the tag is both readable and writeable. OPC Write operations will either change an I/O point at the device, or an operation will be performed.

42 N OMWT-SOFT-OPC Server Tags OMWT-SOFT-OPC Server