2.3 DIP Switches on the iServer

For Dipswitch access you must remove the main board from the case. Refer to the Disassembly Instructions in your iLD Big Display Monitor/Controller Quickstart Manual.

1To change the IP address from the serial port

2To change to default factory settings

3To enable/disable DHCP

4 To enable/disable Terminal Server function

The iServer is shipped with all DIP switches in "OFF" position

ON

1 2 3 4 OFF

ON

1 2 3 4 OFF

Figure 2.2 DIP Switches on the iServer

Table 2.1 Rear Panel Annunciators

Serial Communication Interface Section (For Models with RS485):

TB4 Pin 3

-Rx/Tx

TB4 Pin 2

+Rx/Tx

TB4 Pin 1

Return, Common Ground Shield connection

Network Communication Interface Section:

ETHERNET

RJ45 interface for 10BASE-T connection.

RESET

Button: Used for power reseting the iServer.

COL / ACTIVITY

LED (Red) Blinking: Indicates network activities (receiving or sending packets).

ON / NET LINK

LED (Green) Solid: Indicates good network link.

TX

LED (Yellow) Blinking: Indicates transmitting data to the serial port.

RX

LED (Green) Blinking: Indicates receiving data on the serial port.

5

Page 9
Image 9
Omega Speaker Systems iLD Series manual DIP Switches on the iServer, Network Communication Interface Section