Omega Speaker Systems iLD Series manual Setting a New IP Address over the Network, Access Control

4.6 Setting a New IP Address over the Network

The iServer is shipped with a default IP address of 192.168.1.200 and Subnet Mask of 255.255.255.0. You can configure your PC’s Network connection with an IP address that is in the same range as the iServer’s IP address (192.168.1.x) and connect to the iServer using a crossover network cable between your PC and the iServer.

With this completed, you can go to the DOS-Prompt and ping 192.168.1.200. If you receive responses back (similiar to Figure 4.1), you can go to the Web browser and type in http://192.168.1.200 and it will take you to the Device Type page and then to the Home Page.

Select Access Control button, you’ll be asked for the password. First default Login password is "12345678" and the Admin password is "00000000", then you should be on the administrator setup page were you can simply type in the desired Static IP address, and click Save.

ACCESS CONTROL

Address http://192.168.1.200

ACCESS CONTROL

Login Password		12345678
Admin Password		00000000
Web Server	enable
Host Name	eis21d9
MAC Address 00:03:03:00:21:D9
IP Address	192.168.1.200
Gateway Address		0.0.0.0
Subnet Mask	255.255.255.0
Save		Reset

Power Recycle

Main Menu

Figure 4.12 Access Control

For the IP address to take effect the iServer needs to be turned OFF/ON or press the Reset button.

Once all of this is done, you can connect the iServer to an Ethernet hub using a straight through cable, power it up, and follow the ping routine mentioned in the previous section.

23