4.3.9.1 End Device Parameters (continued) Device Name: Name of this End Device.
Update (Seconds): How often this End Device is sending its data to the Receiver. The default shown “update second” is 0 seconds. This update corresponds to the sampling rate configured by using the Configuration Wizard. For detailed steps on how to configure the sampling rate, please refer to Section 4.1 of the UWTC Manual.
For a more accurate success rate and lost packet information, it is necessary to keep the “Update” time, the same as the “Sampling Rate” of the UWTC End Device.
Sensor 1
This is the field to modify the parameters for the external sensor (process). Remote Display Format: Remote display format is for Server Type continuous mode. It basically defines the way the data is shown on a Remote Display. The default value is 0000000F. This means that the value will be displayed up to 7 digits, followed by the unit of F, for a maximum of 8 characters. Any letters before and/or after the number will be displayed accordingly. Keep in mind that the displayed letters will take away from the available 8 characters.
Make sure that you have enough 0’s to display the entire temperature value. Any extra 0’s will be ignored.
If there is no temperature unit, then the unit will read from the
Setup. “Input” menu if the Controller Remote End Char: The default value is 0D (Hex representation of <CR>). This means that the Meter sends <CR> after each temperature reading. This will be done either in Continuous or Command mode.
This is how the data will appear on the host with 0D assigned:
T75F
T74F
If the end character for instance is 20 (Hex representation of space), the data will then appear as: T75F T74F
If nothing is set for the “Remote End Char” field, the Meter will then forward the data to the LAN with no characters followed.
57
