the “Off” position (factory default) forces the port to negotiate to No Pause mode with its link partner. Setting the Pause DIP-switch to the “On” position allows the port to negotiate to Symmetrical Pause or No Pause mode with its link partner.
When a port is operating in Manual mode, its Pause operation mode is based on the Pause Disable/Enable DIP-switch setting. Setting the Pause DIP-switch to the “Off” position (factory default) forces the port to operate in No Pause mode. Setting the Pause DIP-switch to the “On” position allows the port to operate in Symmetrical Pause mode.
3.2.1.2SW2 - Fiber Full/Half-Duplex “FDX/HDX”
When the DIP-switch is in the Full Duplex “FDX” position (factory default), the fiber port will facilitate a connection that supports Full-Duplex operation. Setting this DIP-switch to Half-Duplex “HDX” facilitates a connection that supports only Half-Duplex.
3.2.1.3SW3 - UTP Auto/Manual Negotiate “AN/Man”
When the DIP-switch is in the UTP auto-negotiate “AN” position (factory default), the UTP port automatically determines the speed and duplex mode of the connecting UTP device. If the connecting UTP device cannot provide the proper signal to indicate its own mode of operation, this DIP-switch should be set to the UTP Manual mode “Man” position. Manual mode requires manually configuring the UTP port to match the speed and the duplex mode of the connecting UTP device using the “10/100” and UTP “FDX/HDX” DIP-switches. Refer to the table below for a detailed explanation.
Switch | Switch | Switch | Function |
SW3 | SW4 | SW5 | |
| | | |
AN | 100 | FDX | The UTP port is set to auto-negotiation |
| | | with the following modes advertised: |
| | | 100F, 100H, 10F, 10H |
AN | 100 | HDX | The UTP port is set to auto-negotiation |
| | | with the following modes advertised: |
| | | 100H, 10F, 10H |
AN | 10 | FDX | The UTP port is set to auto-negotiation |
| | | with the following modes advertised: |
| | | 10F, 10H |
AN | 10 | HDX | The UTP port is set to auto-negotiation |
| | | with the following modes advertised: |
| | | 10H |
MAN | 100 | FDX | The UTP port is set to manual |
| | | negotiation and is forced to: |
| | | 100F |
MAN | 100 | HDX | The UTP port is set to manual |
| | | negotiation and is forced to: |
| | | 100H |
MAN | 10 | FDX | The UTP port is set to manual |
| | | negotiation and is forced to: |
| | | 10F |
| | | |
MAN | 10 | HDX | The UTP port is set to manual |
| | | negotiation and is forced to: |
| | | 10H |
| | | |
3.2.1.4SW4 - UTP 10/100Mbps “10/100”
When the UTP “AN/Man” DIP-switch (described above) is in the manual “Man” position, the “10/100" DIP-switch determines the speed of operation for the UTP port. Setting the “10/100” DIP-switch to UTP
