LEPRECHAUN 90 O.S.A.
WOODBURNING STOVE
INSTALLATION & OPERATING
INSTRUCTIONS
GENERAL
The complete installation must be done in accor- dance with current Standards and Local Codes. It should be noted that the requirements and these publications may be superseded during the life of this manual.
When installing, operating and maintaining your Leprechaun 90 O.S.A. Stove respect basic stan- dards of fire safety. Read these instructions careful- ly before commencing the installation. Failure to do so may result in damage to persons and property. Consult your local Municipal Office, Fire Department, and your insurance representative to determine what regulations are in force. Save these instructions for future reference.
PRE-INSTALLATION ASSEMBLY
Step 1:
TOP FLUE EXIT
Fit part no. 14 over top flue aperture in the hob (Part No. 13) make sure that part no. 14 is well secured on a bed of fire cement.
ASSEMBLY OF OPTIONAL CHIMNEY PIPE SHIELD
HEAT SHIELD
ASSEMBLY
Top Exit:
Fit the head shield as follows:
Screw the 4” 100mm x 1/4” 6mm tie bolts to the back panel (item 11). Fit the four 1” 25mm spacers (item 31) over the tie bolts.
Spacer
Heat Shield
Spacer
After removing the stove from its packing, open the firedoor door and remove the contents from the fire box.
Step 2:
Lay the stove on its side and fit the 4 legs (item 1) with the 1/4” (6.4mm) hex sets screws provided, tighten screws. Stand the stove upright, taking care not to strain the leg bolts.
Step 3:
Install the Hot Plate (item 15) into the large opening of the hob (item 13). Do not remove the Hot Plate when the stove is lighting.
THIS STOVE MAY BE CONNECTED TO EITHER A TOP OR A REAR VENT.
REAR FLUE EXIT
Fit back sealing plate (Part no. 17) over the top flue aperture in the hob (Part no. 13). Fit the flue spigot to part no 11 where part no. 17 was, making sure that part no. 17 and part no. 14 are well secured on a bed of fire cement.
Fionn 90 OSA
Fit the inner heat shield (item 28) with the blanking plate on to the four tie bolts. Now fit the other four 1” 25mm spacers over the tie bolts and fit the outer heat shield (item 30) complete with heat shield blanking plate. Tighten the whole assembly together using the four 1/4” 6mm nuts and washers provided.
DAMPER HANDLE ASSEMBLY
Leprechaun 90 O.S.A.
2
