PI
SA
Management Options | iConverter, Serial Agent |
Network Management
1:Chassis and Module Management
2:Set Module Identifier
Management Module Preferences
3:IP and Control Preferences
4:SNMP Preferences
5:Abandon Preference Changes
6:Save Preference Changes
7:Restore to Factory Defaults
8:Restart Management Module
9:Other Networking Features
Management Module Maintenance
10:Firmware Update
11:Set Date/Time
IP Address | = 192.168.1.220 |
Chassis Number = 1
Enter Choice, (H)elp, E(x)it > 9
PI
SA
Other Networking Features Screen | iConverter, Serial Agent | |
1: | Enable/Disable DHCP Client | Disabled |
2: | Enable/Disable Keep Alive Trap | Disabled |
3: | Keep Alive Trap interval | 10 |
4: | Enable/Disable SW1 Switch Block | Enabled |
5: | Serial Baud Rate | 57600 bps |
Enter Choice, Management Options Screen(0), (H)elp, E(x)it >
To enable DHCP client, select 1 at the Other Networking Features screen and follow the screen prompts to enable DHCP.
To save the new values, select 0 and press <ENTER> to return to the Management Options screen, then select 6 and press <ENTER> to Save Preference Changes.
3.4.1.3Setting the Chassis Number and Name
A Chassis Name, or sysName, can be assigned for identification of the 2FXM2 in the SNMP client. The name can be any
The Chassis Number can remain as 1 (factory default) when the 2FXM2 is installed without an iConverter NMM in the same chassis. When the 2FXM2 is installed in the same chassis as an NMM, then the 2FXM2 must be set to the Chassis Number of the NMM.
To set the Chassis Number, select 4 at the IP and Control Preferences screen, press <ENTER> and follow the instructions to enter the chassis number.
To set the Chassis Name, select 5 at the IP and Control Preferences screen, press <ENTER> and follow the instructions to enter the chassis name.
NOTE: When the NMM is installed into the chassis and is set to Remote OAM, the chassis number of the 2FXM2 is automatically assigned by the NMM.
Page 13
