Omnitron Systems Technology 2FXM2 user manual Oui

ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs to the lower sublayer. If “Discard”, the remote partner is discarding non-OAMPDUs network frames. If “Unknown”, the Multiplexer state of the remote partner is indeterminate.

•Parser Action - Indicates the Parser Action state (“Discard”, “Forward”, “Loopback” or “Unknown”) of the remote ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs network frames to the higher sublayer. If “Loopback” is displayed, the remote partner is looping back non- OAMPDUs network frames. If “Discard” is displayed, the remote partner is discarding non-OAMPDUs network frames. If “Unknown”, the Parser Action state of the remote partner is indeterminate.

•Critical Event - Indicates the Critical Event state (“Yes”, “No” or “Unknown”) of the remote partner. If “Yes” is displayed, the local device has detected a Critical Event. If “No”, the local device has not detected a critical event. If “Unknown,” the Critical Event status of the remote partner is indeterminate.

•Link Fault - Indicates the remote partner has detected a fault in the receive direction (“Yes”, “No” or “Unknown”). If “Yes” is displayed, the receive link is down. If “No”, the receive link is up. If “Unknown,” the link fault status is indeterminate.

•OAM Mode - Indicates the OAM mode (“Active” or “Passive”) of the remote partner.

•Supports - Indicates the supported options (Variable Access “Var”, Link Event Notification “Events”, Loopback “LB”, Unidirectional “UNI” or blank if no options are supported) of the remote partner.

•OUI - Indicates the three hex byte IEEE organizational specific identifier (or blank if unknown) of the remote partner.

802.3ah parameters can be accessed by selecting options 5 from the Port configuration screen. Port 1 configuration screen is displayed.

PI

SA

802.3ah Control - iConverter 2FXM2			iConverter, Serial Agent
Identifier -
Chassis Number = 1	Slot Number = 1		Model Number = 8959N-0	Port # = 1
1: 802.3ah OAM State		Disabled	Local Status
2: OAM Mode		Active	Discovery State	Disabled
3: Loopback Mode		Disabled	Multiplexer State	Forward
4: Loopback Timeout		30 sec	Parser Action	Forward
5: Unidirectional Mode		Disabled
			Remote Status
			Discovery State	Unknown
			Critical Event	No
			Link Fault	No
			Multiplexer State	Unknown
			Parser Action	Unknown
			Mode	Unknown
			Supports	Unknown
			OUI:	Unknown

Enter, Previous Screen (0), (n)ext page, (H)elp, E(x)it >

To configure the 802.3ah parameters for the Port 2, type an n and press <ENTER>.

Page 32