Omnitron Systems Technology GX/TM user manual Oui

“Incomplete”, Discovery is in process, but is not yet completed.

•Multiplexer State - Indicates the Multiplexer state (“Discard”, “Forward” or “Unknown”) of the remote ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs to the lower sublayer. If “Discard”, the remote partner is discarding non-OAMPDUs network frames. If “Unknown”, the Multiplexer state of the remote partner is indeterminate.

•Parser Action - Indicates the Parser Action state (“Discard”, “Forward” or “Loopback”) of the remote ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs network frames to the higher sublayer. If “Loopback” is displayed, the remote partner is looping back non-OAMPDUs network frames. If “Discard” is displayed, the remote partner is discarding non-OAMPDUs network frames.

•Critical Event - Indicates the Critical Event state (“Yes” or “No”) of the remote partner. If “Yes” is displayed, the local device has detected a Critical Event. If “No”, the local device has not detected a critical event.

•Link Fault - Indicates the remote partner has detected a fault in the receive direction (“Yes” or “No”). If “Yes” is displayed, the receive link is down. If “No”, the receive link is up.

•OAM Mode - Indicates the OAM mode (“Active” or “Passive”) of the remote partner.

•Supports - Indicates the supported options (Variable Access “Var”, Link Event Notification “Events”, Loopback “LB” or blank if no options are supported) of the remote partner.

•OUI - Indicates the three hex byte IEEE organizational specific identifier (or blank if unknown) of the remote partner.

802.3ah parameters can be accessed by selecting options 7 from the Port configuration screen. The fiber configuration screen is displayed.

PI

SA

802.3ah Control -iConverter GX/TM			iConverter, Serial Agent
Identifier -
Chassis Number = 1	Slot Number = 3		Model Number = 8923-1	Port = 1
1: 802.3ah OAM State		Disabled	Local Status
2: OAM Mode		Passive	Discovery State	Incomplete
3: Loopback Mode		Disabled	Multiplexer State	Disabled
4: Loopback Timeout		30 sec	Parser Action	Unknown
5: Unidirectional Mode		Not Available
			Remote Status
			Discovery State	Unknown
			Critical Event	Unknown
			Link Fault	Unknown
			Multiplexer State	Unknown
			Parser Action	Unknown
			Mode	Unknown
			Supports	Unknown
			OUI:	00:00:00

Enter, Previous Screen (0), (n)ext page, (H)elp, E(x)it >

To configure the 802.3ah parameters for the UTP port, type an n and press <ENTER>.

Page 34