4.3.8cNode Loopback
The GX/TM has implemented Iometrix cNode Level 1 agent for testing performance metrics. The agent recognizes measurement packets and loops them back to the sending cNode device. Iometrix cNode equipment is required to obtain performance metrics.
cNode configuration is accessed by selecting option 10 from the Port configuration screen.
PI
SA
cNode Control | iConverter, Serial Agent | |
Identifier - |
|
|
Chassis Number = 1 | Slot Number = 3 | Model Number = |
1: | cNode | Loopback | Disabled |
2: | cNode | Rate Limit | 64 Kbps |
Enter Choice, Previous Screen(0), (H)elp, E(x)it >
From the menu, loopback can be enabled or disabled and the rate limit can be selected.
4.3.9Port Statistics
The GX/TM module provides port statistics on both the fiber and UTP port.
The Port Statistics can be viewed by selecting option P from the Module configuration screen.
PI
Module - iConverter GX/TM |
| iConverter, Serial Agent |
| |||||
Identifier - |
|
|
|
|
|
|
|
|
Chassis Number | = | 1 | Switch ON Condition | OFF Condition | H/W | Actual | ||
Slot Number | = | 2 | 1: Fiber Manual | Fiber AN | Off | Off | ||
Model Number | = | 2: UTP Manual | UTP | Off | Off | |||
|
|
| 3: UTP | 10/100 | UTP | 1000 | Off | Off |
Serial Number | = | xxxxxxxx | 4: UTP 10 Mbps | UTP 100 Mbps | Off | Off | ||
Manufacturing Date = | xxxxxxxx | 5: UTP HDX | UTP FDX | Off | Off | |||
Hardware Revision | = | xx | 6: Link Propagate | Link Segment | Off | Off | ||
Software Revision | = | xx | 7: Remote Fault | Normal | Off | Off | ||
|
|
| 8: Symm Fault Det | Normal | Off | Off | ||
LED |
|
| 9: BP A Enabled | BP A Disabled | Off | Off | ||
1: Power | = | On | 10: BP B Enabled | BP B Disabled | Off | Off | ||
2: Power Supply 1 | = | Off | 11: Pause Enabled | Pause Disabled | Off | Off | ||
3: Power Supply 2 | = | On | 12: Slave Only | Master/Slave | Off | Off | ||
4: Power Supply 3 | = | Off | 13: UTP | UTP | Off | Off | ||
5: Fiber Link | = | Off | 14: UTP Crossover | UTP Through | Off | Off | ||
6: BP Master | = | Off | 15: Not Available |
|
|
|
| |
7: UTP 100+10 Link = | Off | 16: Not Available |
|
|
|
| ||
8: UTP 1000+10 Link= | Off | OAM settings: |
|
|
|
| ||
9: UTP FDX | = | Off | 17: IP Protocol State | Off |
|
| ||
|
|
| 18: Management Mode | ah OAM |
|
| ||
Toggle |
| |||||||
|
|
|
|
|
|
|
|
|
Page 43
