Changing System or Radio Configurations | Omron DDAA1000/SRM

DDAA1000/SRM User Guide

Changing System or Radio Configurations

To access the system or radio setups the user must remove all connectors from the DDAA1000/SRM or DD1000/SRM, then remove the cover and change the jumpers at location P1 and P2, and add a serial data cable (SRM6200E-SLC), supplied by Data-Linc Group, to connector P3. These jumper settings must be returned to the RUN/RF settings after reconfiguring the system or the radio or the units will not operate. See layout drawing.

There are 4 configurations of the jumpers.

1. RUN / RF	Normal DDAA/1000 and DD1000/SRM operations
2. CONFIG / RF	Serial port P3 to PC (computer) to access the radio parameters
3. CONFIG / PIC	To reprogram the system configuration setup memory
4. RUN / EXT	Factory use only - do not use

If changing the system configuration go to Appendix B.

If changing the radio parameters go to Appendix C.

Figure 9: Layout Drawing

12	DATA-LINC GROUP

PN 161-09981-002C

rev 8/04

Image 14

Omron DDAA1000/SRM manual Changing System or Radio Configurations, Layout Drawing

Contents

DDAA1000/SRM FCC Notification Product User Guide Table of Contents DATA-LINC Group Introduction DDAA1000 and DD1000 Teminal Block Power ConnectorAntenna Connectoin Type Discrete Operation Connections Point-to-Point Discrete Operation Master Remote Point-to-Multipoint Discrete Operation Master Point-to-Point Analog System Supply loop powerAnalog Operation Needed. The DDAA1000 unites do not Connection of a flow meter to the DDAA1000/SRM unit Master or Remote Factory Configuration Process Point-to-Multipoint Analog System Point-to-Multipoint Analog Operation Point-to-Multipoint Analog Example Remote Changing System or Radio Configurations Layout Drawing Technical Specifications Troubleshooting Technical Support Product WarrantyReturn Material Authorization Contact Information Appendix a TOP DDAA1000 DD1000 Configuration Appendix B DATA-LINC Group Ddaa Eeprom MENU** *SET Caplck DATA-LINC Group Appendix C Radio Configuration Terminal Settings Main Menu Point-to-Point Remote Main Menu Option 0 Set Operation ModePoint-to-point Master Point-to-Multi-Point Master Point-to-Point Repeater Point-to-Point Remote/Master SwitchableDDAA1000/SRM User Guide Point-to-Point Remote/Repeater Point-to-Multi-Point Repeater ModBus RTU Main Menu Option 1 Set Baud RateAvailable data word length and parity selections Main Menu Option 2 Edit Call Book Call Book Menu Edit Call Book in Multi-Point Systems Entry Number Repeater 000-0000 Max Packet Size and 2 Min Packet Size Selections Main Menu Option 3 Edit Radio Transmission CharacteristicsFreqKey DDAA1000/SRM User Guide Minimum Packet Size Settings bytes Maximum Packet Size Settings where RF Data Rate=3 Xmit Rate RF Data Rate Remote Security DDAA1000/SRM User Guide RF Xmit PowerPower Transmit Settings RTS to CTS MCU speed DDAA1000/SRM User Guide Lowpower ModeHigh Noise Average Noise Level Average Signal LevelMain Menu Option 4 Show Radio Statistics Overall Rcv Rate % Multi-Point Operation Radio TemperatureDDAA1000/SRM User Guide Number of Disconnects Main Menu Option 5 Edit Multi-Point Parameters Multi-Point Parameters SubNet ID DiagnosticsRemote/Repeater Radio ID Main Menu Option 8 Password Changing a Password Disabling Password DDAA1000/SRM and DD1000/SRM Placement Locations