Point-to-Point Discrete Operation | Omron DDAA1000/SRM specs

DDAA1000/SRM User Guide

Point-to-Point Discrete Operation

The following illustrates an example of a point-to-point discrete system. The “Contact Closure Input” may be as simple as a bare wire or be connected to an output of an I/O module. This is an example of turning a lamp at the Master unit by closing a contact at the Remote unit using a discrete output.

Point-to-point discrete operations are bi-directional. An input on the Remote will activate same numbered output on the Master. A contact closure on an input of the Master will close the output on the Remote on the same contact.

Figure 4: Point-to-Point Discrete Operation Example

Dry Contact Closure

8 7 6 5 4 3 2 1 G	8 7 6 5 4 3 2 1 G
Contact Closure Input	Contact Closure Output

DC Supply

+ -

8 7 6 5 4 3 2 1 G

8 7 6 5 4 3 2 1 G

Contact Closure Input

Contact Closure Output

Master

Remote

6	DATA-LINC GROUP

PN 161-09981-002C

rev 8/04

Image 8

Omron DDAA1000/SRM manual Point-to-Point Discrete Operation, Master Remote

Contents

DDAA1000/SRM FCC Notification Product User Guide Table of Contents DATA-LINC Group Introduction DDAA1000 and DD1000 Teminal Block Power ConnectorAntenna Connectoin Type Discrete Operation Connections Point-to-Point Discrete Operation Master Remote Point-to-Multipoint Discrete Operation Master Supply loop power Analog OperationPoint-to-Point Analog System Needed. The DDAA1000 unites do not Connection of a flow meter to the DDAA1000/SRM unit Master or Remote Factory Configuration Process Point-to-Multipoint Analog System Point-to-Multipoint Analog Operation Point-to-Multipoint Analog Example Remote Changing System or Radio Configurations Layout Drawing Technical Specifications Troubleshooting Product Warranty Return Material AuthorizationTechnical Support Contact Information Appendix a TOP DDAA1000 DD1000 Configuration Appendix B DATA-LINC Group Ddaa Eeprom MENU** *SET Caplck DATA-LINC Group Appendix C Radio Configuration Terminal Settings Main Menu Main Menu Option 0 Set Operation Mode Point-to-point MasterPoint-to-Point Remote Point-to-Multi-Point Master Point-to-Point Remote/Master Switchable DDAA1000/SRM User Guide Point-to-Point Remote/RepeaterPoint-to-Point Repeater Point-to-Multi-Point Repeater ModBus RTU Main Menu Option 1 Set Baud RateAvailable data word length and parity selections Main Menu Option 2 Edit Call Book Call Book Menu Edit Call Book in Multi-Point Systems Entry Number Repeater 000-0000 Max Packet Size and 2 Min Packet Size Selections Main Menu Option 3 Edit Radio Transmission CharacteristicsFreqKey DDAA1000/SRM User Guide Minimum Packet Size Settings bytes Maximum Packet Size Settings where RF Data Rate=3 Xmit Rate RF Data Rate DDAA1000/SRM User Guide RF Xmit Power Power Transmit SettingsRemote Security RTS to CTS MCU speed DDAA1000/SRM User Guide Lowpower ModeHigh Noise Average Signal Level Main Menu Option 4 Show Radio StatisticsAverage Noise Level Overall Rcv Rate % Multi-Point Operation Radio TemperatureDDAA1000/SRM User Guide Number of Disconnects Main Menu Option 5 Edit Multi-Point Parameters Multi-Point Parameters Diagnostics Remote/RepeaterSubNet ID Radio ID Main Menu Option 8 Password Changing a Password Disabling Password DDAA1000/SRM and DD1000/SRM Placement Locations