Antenna Connectoin Type, Power Connector | Omron DDAA1000/SRM

DDAA1000/SRM User Guide

Table 1: LED Description

	CD	Carrier Detect LED. When the units have established an RF Link this LED will be on solid.

	Tx	Transmit LED. Will flash when the unit is sendng data to the receiving unit.

	Rx	Receive LED. Flashes when receiving data being sent by transmitting unit.

	Pwr	Power LED. Flashes on solid when unit has power applied.

	Status	The status LED will be off when communication is working properly. LED flashes or stays on
	Status	steadily when a communication problem exists. (Master unit only)


Figure 2: Normal User Connection

Power

Antenna

Antenna Connectoin Type

Thread Type	Standard Thread

Gender	Female

Connector	SMA

Power Connector

Dimensions of Post	2 mm

Dimensions of Hole	6.5 mm

Polarity	Center Pin Positive

Voltage	12VDC Nominal , 10.5-18VDC

Current	160mA Idle, 660mA Peak on Transmit

Teminal Block

Wire Size	12-26 AWG

4	DATA-LINC GROUP

PN 161-09981-002C

rev 8/04

Image 6

Omron DDAA1000/SRM manual Antenna Connectoin Type, Power Connector, Teminal Block

Contents

DDAA1000/SRM FCC Notification Product User Guide Table of Contents DATA-LINC Group Introduction DDAA1000 and DD1000 Power Connector Antenna Connectoin TypeTeminal Block Discrete Operation Connections Point-to-Point Discrete Operation Master Remote Point-to-Multipoint Discrete Operation Master Point-to-Point Analog System Supply loop powerAnalog Operation Needed. The DDAA1000 unites do not Connection of a flow meter to the DDAA1000/SRM unit Master or Remote Factory Configuration Process Point-to-Multipoint Analog System Point-to-Multipoint Analog Operation Point-to-Multipoint Analog Example Remote Changing System or Radio Configurations Layout Drawing Technical Specifications Troubleshooting Technical Support Product WarrantyReturn Material Authorization Contact Information Appendix a TOP DDAA1000 DD1000 Configuration Appendix B DATA-LINC Group Ddaa Eeprom MENU** *SET Caplck DATA-LINC Group Appendix C Radio Configuration Terminal Settings Main Menu Point-to-Point Remote Main Menu Option 0 Set Operation ModePoint-to-point Master Point-to-Multi-Point Master Point-to-Point Repeater Point-to-Point Remote/Master SwitchableDDAA1000/SRM User Guide Point-to-Point Remote/Repeater Point-to-Multi-Point Repeater Main Menu Option 1 Set Baud Rate Available data word length and parity selectionsModBus RTU Main Menu Option 2 Edit Call Book Call Book Menu Edit Call Book in Multi-Point Systems Entry Number Repeater 000-0000 Main Menu Option 3 Edit Radio Transmission Characteristics FreqKeyMax Packet Size and 2 Min Packet Size Selections DDAA1000/SRM User Guide Minimum Packet Size Settings bytes Maximum Packet Size Settings where RF Data Rate=3 Xmit Rate RF Data Rate Remote Security DDAA1000/SRM User Guide RF Xmit PowerPower Transmit Settings RTS to CTS DDAA1000/SRM User Guide Lowpower Mode High NoiseMCU speed Average Noise Level Average Signal LevelMain Menu Option 4 Show Radio Statistics Overall Rcv Rate % Radio Temperature DDAA1000/SRM User Guide Number of DisconnectsMulti-Point Operation Main Menu Option 5 Edit Multi-Point Parameters Multi-Point Parameters SubNet ID DiagnosticsRemote/Repeater Radio ID Main Menu Option 8 Password Changing a Password Disabling Password DDAA1000/SRM and DD1000/SRM Placement Locations