Klinkmann Automation Omron Ethernet DAServer | 63 |
|
| UDP/TCP socket | and 8. |
|
|
| number was not within |
|
|
|
| the proper range |
|
|
|
|
|
|
|
01
An incorrect memory area or unavailable expansion mem. area has been used.
Check the command’s memory area code. Check whether right controller type configured in DAServer. Check whether controller does has polled memory areas.
DASProtFail
03
The first address is in inaccessible area.
Set the first word that is DASProtFail in an accessible area.
Check whether right controller type configured in DAServer.
22: Status | 0F |
error |
|
|
|
The same socket service is already in progress at the specified socket number.
Use the socket status flag in PC memory to be sure that socket service has finished before starting services again. (Error deals with Ethernet communication programming in PLC’s user program).
DASProtFail
10
23:05
Environmen t error
The specified socket is not open.
IP address conversion failed.
Open the socket.
Check the IP address and subnet mask in the System Setup and be sure that settings are correct.
DASProtFail
DASProtFail
07
IP address conversion is set for automatic conversion only.
Check the mode settings for System Setup. This error will be generated for the READ IP ADDRESS command only.
DASProtFail
25: Unit | 03 |
error |
|
|
|
05
I/O setting error. (The I/O table differs from the actual Unit configuration).
CPU bus error. (An error occurred during
Either change the actual | DASProtFail |
configuration to match |
|
the registered one or |
|
generate I/O table again. |
|
|
|
Check the Units and | DASProtFail |
cable connection and |
|
|
|
Omron Ethernet DAServer Ver 1.x User Manual Rev 1.4 | 17014m14 |
