4-2SectionProgramming Console Operations
40
SHIFT B1<MONITOR>
The buzzer will not sound
when “BZ” is not displayed.
3. Press the SHIFT and then the 1 Key again to turn the buzzer back on.
SHIFT B1<MONITOR> BZ
4-2-5 Reading UM Area Information
This operation is used to display the status of settings in the User Memory (UM)
area, and its capacity.
RUN MONITOR PROGRAM
OK OK OK
1, 2, 3... 1. Press the CLR Key to bring up the initial display.
CLR 00000
2. Press the FUN and VER Keys.
FUN VER
00 04.1
CM LAD
I/O command area size
User program area size
4-2-6 Setting Expansion Instructions
This operation is used to read and change the function codes assigned to certain
instructions.
Set the expansion instructions before inputting the program. The SRM1 will not
operate properly if the function codes in the program are assigned incorrectly.
When setting the expansion instructions, set the PC Setup’s DM 6602 bits 8
through 11 to “1.”
Two function codes cannot be assigned to a single instruction.
For the SRM1 expansion instruction default settings, refer to the
/CPM1/CPM1A/CPM2A/CPM2C/SRM1(-V2) Programming Manual (W353).
RUN MONITOR PROGRAM
Read OK OK OK
Set No No OK
1, 2, 3... 1. Press the CLR Key to bring up the initial display.
CLR 00000
2. Press the EXT Key to display the settings.
EXT INST TBL READ
FUN017:ASFT
3. Use the Up and Down Arrow Keys to scroll through the function codes and
read their corresponding instructions.
↓/↑INST TBL READ
FUN061:INI