!
!
4-2SectionProgramming Console Operations
54
RUN MONITOR PROGRAM
No OK OK
Words SR 253 to SR 255 cannot be changed.
Caution Before changing the contents of I/O memory, be sure that the changes will not
cause equipment to operate unexpectedly or dangerously. In particular, take
care when changing the status of output bits. The PC continues to refresh I/O
bits even if the PC is in PROGRAM mode, so devices connected to output points
may operate unexpectedly.
1, 2, 3... 1. Monitor the status of the desired word according to the procedure described
in 4-2-13 Bit, Digit, Word Monitor. If two or more words are being monitored,
the desired word should be leftmost on the display.
(Word monitor)
D0000
0119
2. Press the CHG Key to begin hexadecimal, BCD data modification.
CHG PRES VAL?
D0000 0119 ????
3. Input the new PV and press the WRITE Key to change the PV.
The operation will end and the normal monitoring display will return when
the WRITE Key is pressed.
C2A0A0WRITE D0000
0200
4-2-22 Binary Data Modification
This operation is used to change the status of a word’s bits when the word is
monitored using the procedure described in 4-2-15 Word Monitor. It is pos-
sible in MONITOR or PROGRAM mode only.
RUN MONITOR PROGRAM
No OK OK
Bits SR 25300 to SR 25507 and timer/counter flags cannot be changed.
Caution Before changing the contents of I/O memory, be sure that the changes will not
cause equipment to operate unexpectedly or dangerously. In particular, take
care when changing the status of output bits. The PC continues to refresh I/O
bits even if the PC is in PROGRAM mode, so devices connected to output points
may operate unexpectedly.
1, 2, 3... 1. Monitor the status of the desired word according to the procedure described
4-2-15 Word Monitor.
(BInary monitor)
c010 MONTR
1000010101010101
Bit 15 Bit 00
2. Press the CHG Key to begin binary data modification.
CHG c010 CHG?
1000010101010101
A flashing cursor will appear over bit 15. The cursor indicates which bit can
be changed.