How to Fill the Medication Bottle
Have you removed Mask Adapter and the supplied Mouthpiece?
(For how to assemble the Main Unit, refer to Page 8)
How to Fill the Medication Bottle
5Attach the Medication Bottle to the Main Unit.
– | If the Medication Bottle is not installed | Click |
| correctly, the power will not turn on. | |
|
| |
– | If the Electrodes on the Main Unit are | Align both |
| severely stained, the unit will not nebulize |
|
How to Fill the Medication Bottle
1Remove Medication Bottle from the Main Unit.
2Open the Mesh Cap.
Hold the medication bottle as if covering it with your hand.
Click
Press gray tabs on both side of Medication Bottle at the same time lift upwards.
Lift up the mesh cap while pressing your thumb hard on the brim.
normally. In that case, wipe off the stain. | electrodes with |
each other. | |
(Refer to Page 17) |
|
6 | Correct Use |
Attach the Mouthpiece, Mask Adapter. | |
| ofthe Unit |
Unit | Do not open the | |
the | ||
bottle cap. |
Use of | 3 Fill Medication Bottle. |
Correct | Be careful to prevent the Mesh Cap from closing |
| |
| as shown in the Figure. |
| – The maximum capacity of Medication Bottle is 7 ml. |
4 | Close the mesh cap. | Check that the | |
Mesh Cap is closed. | |||
|
|
–Be sure to check that the Mesh Cap is engaged. If it is not engaged, medication will leak.
|
| You have | How to | |
|
| Fill the | ||
|
| finished assembly. | ||
7 | Attach the Child’s Inhalation Mask or the Mouthpiece. | |||
Medication Bottle | ||||
• | How to install the Child’s Inhalation Mask | • How to install the Mouthpiece | ||
|
|
| ||
You have finished assembly.
12
